EzUHF Transmitter

The EzUHF transmitter is a true powerhouse with a wealth of connectivity broadening the horizon for each FPV pilot. Headtracking support has now been taken out of the hands of the RC transmitter and is exclusively handled by the EzUHF transmitter, so any radio can be used with your TrackR2 now. Support for any radio battery voltage is guaranteed as well, as the EzUHF transmitter has a power-in jack which will accept a 3S LiPo, so no soldering in your precious RC transmitter is required. For Futaba systems using a 9.6V battery or 3S LiPo the EzUHF transmitter can be powered directly from it, with just a single cable. The battery voltage, either from the external battery, or provided by the radio, obviously is monitored and an audible alarm will sound when the battery gets low.

The EzUHF transmitter comes with an auxilary input that’ll offer exciting upcoming new features for FPV use. The EzUHF transmitter also comes with a power boost switch, which boosts the power if you happen to put yourself in a tight spot and need to regain control. And we’ve not even touched upon the full duplex capabilities of the EzUHF solution, which is exclusively available on the EzUHF transmitter and the 8-ch EzUHF receiver, turning both into full blown transceivers and hence opening the door for exciting future possibilities.

There's more, as all EzUHF products feature a common USB connector, even the miniscule 4-ch EzUHF receiver, which, in combination with our application software, will allow you to set up your receivers in just the way you like. Mikrokopter mode, the cloning of channels, diagnostics, firmware updates, etc. etc. all available with the click of your mouse or a press of a button, no soldering required, nor any fancy non-standard cable. Convenient, simple and intuitive, leaving you with more time to enjoy your flying, rather than spending hours or days setting up your equipment.

All of that and many, many more upcoming features which further allow integration of our products and turn the electronics powering your FPV plane into a reliable, rocksolid, but above all a plug ‘n fly solution that you get to enjoy every time you fly.

Notice: The use and operation of this product in the USA and other countries may require an amateur/ham radio license, and some countries may forbid its use entirely. It is the responsibility of the purchaser to ensure that the use of this product meets the requirements imposed by your government’s rules and regulations for RF devices. Do not purchase this product if you are unsure of the government requirements or are not able to comply with them. Hobby Hobby cannot be held responsible for your actions if you purchase and/or use this product in violation of your government's regulations.




Dimensions:


Width: 75mm
Height: 25mm
Length: 85mm
Weight: 120 grams (without antenna)







Content of the pacakge:

1 x EzUHF Transmitter
1 x UHF rubber duck antenna
1 x Futaba cable
1 x Power pigtail